Created by class: Tube Flat Pattern Engine. at: 11/19/2019 9:04:10 AM Engineer name: Robert P Kiser, PE Computer name: XPS-8930 Tube Type was: ole Tube Flat Configuration was: 12 Flats Number of flats = 12 Cross section is elliptical? False Flats are numbered counter-clockwise, looking from above? False Tube is mitered? = False Bevel cut bottom end? = False Bevel cut top end? = False Bevel cut long sides? = False Bevel angle for ends = 45 (deg) Bevel angle for long sides = 15 (deg) Tube Centerline length = 516.0000 (in) Bent up and Welded: Bottom End Width (Flat/Flat) = 30.2625 (in) Top End Width (Flat/Flat) = 17.3867 (in) Bent up and welded: Bottom End Width (Point/Point) = 31.3300 (in) Top End Width (Point/Point) = 18.0000 (in) In the flat: Bottom End Corner-to-Corner Width = 48.1189 (in) In the flat: Top End Corner-to-Corner Width = 27.4200 (in) In the flat: Bendline Length = 516.0430 (in) In the flat: Bottom End Bendline-to-Bendline Width = 8.0203 (in) In the flat: Top End Bendline-to-Bendline Width = 4.5703 (in) Point Number at Seam # 1 = 9 Seam # 1 Degrees from X Axis = 0.00 Customer Name: Test Customer Job Number: J1234 Structure Number: S100 Piece 1 of 2 pieces. Part Number: J1234-9876 Material Name: not specified Thickness = 0.2500 (in) Neutral Axis as % of Thickness = 34.0000 Bottom End Rotation about X = 0.0000 Bottom End Rotation about Y = 0.0000 Top End Rotation about X = 0.0000 Top End Rotation about Y = 0.0000 Tube Widths were input using Point-To-Point? True DXF output was rotated 180 degrees? True Seam edges were offset? False Seam Offset Distance = 0.12500 (in) Runoff tab location = Neither End Runoff Tab Half-Width = 1.50000 (in) Runoff Tab Stickout = 3.00000 (in) Second trap of double seam tube to be supressed? False Alignment of flat pattern outline with CNC table X axis = Align Starting Long Side With X Axis Note: Running in Prototype Mode!